Section 8: Appliance Setup; Remove Shipping Materials; Top To Rear Conversion - Heat & Glo TIARAII-BK-B Owner's Manual

8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
rebox.
B. Top to Rear Vent Conversion
KIT CONTENTS: Rear vent grille: NG ori ce (.111); LP
ori ce (.063)
TOOLS REQUIRED: Power drill; #2 Phillips bit; high-temp
sealant (optional).
Remove top grille, as highlighted.
Figure 8.1
CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses during
installation.
Remove vent pipe adapter and gasket by remov-
Figure 8.2
ing 4 screws. Save the screws. (If gasket breaks, apply
high-temp sealant to bottom of adapter before installing as
shown in Figure 8.8.)
28
Figure 8.4
Either remove the four screws holding the back shield in
place, saving the screws, OR break the seal on the knock
out and discard the knock out.
Figure 8.5
the screws.
Figure 8.6
attach with the four screws removed in Figure 8.2.
Heat & Glo • TIARA II-B • 7011-148 Rev. L • 6/14
Remove the inner collar adapter.
Figure 8.3
Screws
Locate the knock out on rear of appliance.
REAR PLATE REAR PLATE
AND GASKET AND GASKET
Remove rear access plate and gasket. Save
Place cover plate and gasket over top vent and
Screws