Heat & Glo TIARAII-BK-B Owner's Manual page 32

J. Optional Blower (Cont'd)
BLOWER
CONTROL
KNOB
CONTROL
NUT
SPEED
CONTROL
Compare CONTENTS OF CARTON with the
Figure 8.22
actual parts received. If any parts are missing or damaged,
contact your dealer before starting installation. Do not
install a damaged blower kit.
From the rear of the appliance, slide the blower
Figure 8.23
into the blower housing with the magnetic strips down. The
blower openings should be at the front.
From the front of the appliance, thread the blower
Figure 8.24
cord plug through hole on bottom of cord bracket assembly,
and plug blower power cord into blower receptacle labeled
"FAN" on power cord.
HOLE FOR HOLE FOR
BLOWER/ACCESSORY PLUGS BLOWER/ACCESSORY PLUGS
32
WING
NUT
TEMPERATURE
SENSOR
SWITCH
Heat & Glo • TIARA II-B • 7011-148 Rev. L • 6/14
WING NUT
Slide temperature sensor switch/bracket
Figure 8.25
assembly onto the 10-32 screw located on the left
underside of the appliance. Secure the bracket assembly
with the wing nut provided.
Disconnect the two wire ends connected together on
the power cord. Connect female end to one side of
temperature sensor switch.
Connect one end of the black wire provided with the kit to
the remaining wire end on power cord.
Feed loose ends of the black and blue wires through the
orange grommet in fan housing.
SCREWS
Remove valve access cover from back of
Figure 8.26
appliance by removing the three screws indicated.
SPEED CONTROL
Remove the knob and lock nut from the speed
Figure 8.27
control. Install speed control onto access panel with stem
sticking out the pre-punched hole. Attach the lock nut
tightly and re-attach the knob on the stem.
Attach blue and black wires routed through orange
grommet in fan housing to the speed control. Re-install
access panel.
3
LOCK NUT
AND STEM