Positioning The Logs; Mineral Wool; Accessories; Optional Blower - Heat & Glo TIARAII-BK-B Owner's Manual

G. Positioning the Logs
Place rear log onto the two locating pins located
Figure 8.19
on the rear log shelf in the back of the rebox.
#2
Place left and right logs into recesses cut out for
Figure 8.20
them on the left and right side of the burner. Log installa-
tion is complete.
H. Mineral Wool
Explosion Risk.
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
Apply dime size pieces sparingly along front
Figure 8.21
edge of burner. Do not completely block ports.
#1
#1
#3
WARNING
Heat & Glo • TIARA II-B • 7011-148 Rev. L • 6/14
I. Accessories
Install approved accessories per instructions included with
accessories. Refer to Section 12 for appropriate accesso-
ries.
WARNING
Shock or Fire risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
J. Optional Blower
Kit Contents: Blower; speed control; lock nut; control
knob; temperature sensor switch; wing nut; 2 high-temp
black wires; 1 high-temp blue wire.
Tools Required: Philips head screwdriver; 1/2 in. wrench.
The GFK-160A blower has been designed to circulate room
air through the appliance to enhance heat output.
The blower system operates on 120 VAC, 60 Hz power. This
is available through a receptacle in the factory installed junc-
tion box on the underside of the appliance.
31