Section 8: Appliance Setup; Remove Shipping Materials; Accessories; Door Crown Installation - Heat & Glo MISSION-BAY Owner's Manual

8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
B. Accessories
Install approved accessories per instructions included with
accessories. Refer to Section 12 for appropriate accesso-
ries.
WARNING
Shock or fire risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids
warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
C. Door Crown Installation
2 Screws
2 Vis
Remove door from appliance.
Figure 8.1
Remove existing black crown by removing the four screws
indicated from the back side of the face, and pull the crown
off of the door. Set the new plated crown in place, reinsert
and tighten screws.
IMPORTANT! PREVENT PERMANENT STAINING! Use a
soft cloth and a window cleaning solution to clean all
fingerprint oils from the plated surface of crown PRIOR
to lighting the appliance.
Page 28
D. Grille Installation
Figure 8.2
from the left and right sides at the top of the door. Slide grille
off, remove the screws and set aside. Discard the original
grille.
On a protective surface using the four screws just removed,
set screws about halfway into pre-drilled holes in gold grille.
Slide the screws into the slots in the door and tighten screws
completely.
E. Brick Installation
NOTE: The brick panels are packaged with the log set.
2 Screws
2 Vis
Figure 8.3
remove the door from the appliance and set aside.
Locate the two tabs on the left and right side of the firebox.
These secure the brick panels in place.
Heat & Glo · Mission Bay · 250-7512F
To remove the original grille, loosen the four screws
Brick Panel tabs
Remove brick panels from packaging. Carefully
July 12, 2006