Table of Contents
Advertisement
8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Accessories
Install approved accessories per instructions included with
accessories. Refer to Section 12 for appropriate accesso-
ries.
WARNING
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
C. Top to Rear Vent Conversion
See Service Parts list in Section 12 for Kit information.
Kit Contents: Rear vent grille, NG orifi ce (.096), LP orifi ce
(.059)
Tools Required: Power drill; #2 Phillips bit; high-temp seal-
ant (optional).
CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses during
installation.
Figure 8.1
Remove top grille, as highlighted.
Figure 8.2
ing 8 screws. Save the screws. (If gasket breaks, apply
high-temp sealant to bottom of adapter before installing as
shown in Figure 8.8.)
Figure 8.3
Figure 8.4
remove the four screws holding the back shield in place,
saving the screws, OR break the seal on the knock out and
discard the knock out.
Heat & Glo • TIARA I-C • 7066-100 Rev. D • 12/11
Remove vent pipe adapter and gasket by remov-
Remove the inner collar adapter.
Screws
Locate the knock out on rear of appliance. Either
Screws
29
Advertisement
Table of Contents
