Lamp Settings - Chauvet Lrgrnd 300E Beam User Manual

Lamp Settings

Lamp On / Off
Lamp Status During
Power On
Remote Turn Off
Lamp On if DMX Present
Lamp Off if DMX Absent
Fan Speed
Lamp Strike Delay
Fixture Shut Off Delay
Legend 300E Beam User Manual Rev. 01f
Continued from previous page
From the Main Menu, highlight Fixture Settings and press <ENTER>.
The lamp will not ignite if the ambient temperature is 104º F (45º C) or higher.
1) Highlight On/Off (the current setting will show).
2) To turn the lamp on or off, press <ENTER> (a pop up window will open).
a) Select ON to turn the lamp on or OFF to turn the lamp off.
b) Accept the selected option.
1) Highlight State/Power On (the current setting will show).
2) To change the lamp status during power on, press <ENTER> (a pop up window will
open).
a) Select ON to turn on the fixture and the lamp simultaneously or OFF to turn on
the fixture without turning on the lamp.
b) Accept the selected option.
1) Highlight Off Via DMX (the current setting will show).
2) To enable/disable remote turn off, press <ENTER> (a pop up window will open).
a) Select YES to enable fixture turn off from either a DMX controller or its power
switch, or NO to turn the fixture off only from its power switch.
b) Accept the selected option.
1) Highlight On if DMX On (the current setting will show).
2) To turn the lamp on when DMX is present, press <ENTER> (a pop up window will
open).
a) Select YES to turn the lamp on if DMX signal is present, or NO to turn the lamp
on only from the control panel.
b) Accept the selected option.
1) Highlight Off if DMX Off (the current setting will show).
2) To turn the lamp off when DMX is absent, press <ENTER> (a pop up window will
open).
a) Select YES to turn the lamp off if DMX signal is absent, or NO to turn the lamp
off only from the control panel.
b) Accept the selected option.
1) Highlight Cooling Mode (the current setting will show).
2) To change the fan speed setting, press <ENTER> (a pop up window will open).
a) Select AUTO to allow the fixture's controller to set the fan speed, or HIGH to set
the fan speed to high mode.
b) Accept the new selection.
1) Highlight Ignition Delay (the current setting will show).
2) To set the lamp strike delay, press <ENTER> (a pop up window will open).
a) Select the delay before the lamp strikes after power up in seconds (0~255).
b) Accept the new value.
1) Highlight Low Power Delay (the current setting will show).
2) To set the lamp shut off delay, press <ENTER> (a pop up window will open).
a) Select the delay before the fixture powers off after lamp off in seconds (0~255).
b) Accept the new value.
Continues on the next page
Operation
-13-