Set Print Station; Select User-Defined Or Resident Character Sets - IBM SUREMARK TF6 User Manual

Attention:
shorter than the actual document. If you set the document length too long the
printer will feed the document out of the printer roller and an error will be generated.

Set print station

EIA-232 Syntax:
where:
Default:
Remarks:

Select user-defined or resident character sets

EIA-232 Syntax:
where:
Default:
Remarks:
134
SureMark Printers User's Guide
(676 dots) / (10 = dots per character) = 67 characters per line
v for 120 DPI
[(motor steps - 75) * 2.5] - 10 = dots per line
v or for a 6-inch document
(540 dots) / (10 = dots per character) = 54 characters per line
or
It is recommended that you set the document length a few steps
ESC c 0 n or X'1B;6330;n'
n Specifies the print station.
Bit # ↓ Station
(LSB) 0 Reserved
1 Customer Receipt Station
2 Document Station - Portrait Mode
3 Document Station - Landscape Mode
4 Reserved
5 Reserved
6 Reserved
( MSB) 7 Reserved
n = 02
See "Document handling" on page 181.
Only one station can be set at a time. If you select more than one station,
the command is ignored.
ESC % n or X'1B;25;n'
n=00 Select resident character sets
n=01 Select user-defined character sets
n = 00
See "Character fonts" on page 98 and "Download user-defined characters"
on page 118.
Updated April 2, 2009