Table of Contents
Advertisement
Updated April 2, 2009
v Microcode update
v Logo download
v Message download
v Printer Configuration Utility, which includes:
Using the reference/service diskettes (Models TI1 and TI2)
1. Load the reference/service diskette. See the hardware service manual for your
2. Select Test Menu.
3. Select Run POS Device Tests for an RS-485 connection. Select EIA-232 4610
4. If another system is attached, select the system whose printer you want to
5. Select Printer Utilities.
6. Select the adjustment you want to make from the menu.
– Scanner calibration
– Print current adjustment values (see Figure 16 on page 36)
– Character alignment procedure (see Figure 16 on page 36)
– Backlash adjustment (document landscape, see Figure 16 on page 36)
– DI front load print line adjustment (see Figure 16 on page 36)
– Set serial number
– Reset printer statistics
– Set printer type (4610 model configuration)
system for reference/service diskette procedures.
Printer Test for an EIA-232 connection.
adjust. This is unnecessary when there is no other system attached.
v Print current adjustment values: see Figure 16 on page 36.
v Character alignment procedure: see Figure 16 on page 36.
v DI front load print line adjustment: see Figure 16 on page 36.
v Document landscape adjustment: see Figure 16 on page 36.
v Engineering use only
v Change 4610 Model Configuration
v Reset printer statistics
Note: Because the first four adjustments affect only the document insert
station, they are not displayed as selectable options if the printer is a
single-station SureMark.
Chapter 3. SureMark installation, service, and utility software
35
Advertisement
Table of Contents
