Table of Contents
Advertisement
Value (Bits 0–3)
Note
0000–0
C
0001–1
C#
0010–2
D
0011–3
D#
0100–4
E
0101–5
F
0110–6
F#
0111–7
G
Default:
Purpose:
Remarks:
Enable or disable upside-down printing
This command is not supported for Models TI1 and TI2. This command is only
supported in the thermal station.
EIA-232 Syntax:
where:
Default:
Purpose:
144
SureMark Printers User's Guide
Bits 0–3
The note. Bit 0 is the LSB.
Bits 4–5
The octave.
Bit 6
Reserved.
Bit 7
Volume. 0 = loud, 1 = soft.
Value (Bits 0–3)
1000–8
1001–9
1010–A
1011–B
1100–C
1101–D
1110–E
1111–F
n = X'00'
To enable or disable the beeper.
v Any value other than X'00' or X'FF' is treated as an amount of time that
the beeper is to be enabled. The time is calculated as n1×0.1 seconds.
v To stop a beep command early, send the Disable Beeper command.
v Timed beeps can be chained together. They can also be downloaded as
canned messages.
v A value of n2=X'2F' is recommended for the most audible tone.
v Set bits 0–3 to 1100 to put a timed silence in a beep sequence.
ESC { n or X'1B 7B n'
n enables or disables upside-down printing.
X'00'
Disable upside-down printing.
X'01'
Enable upside-down printing.
n = X'00'
When the printer is wall-mounted, the front of the printer points up.
Note
Value (Bits 4–5)
G#
00–0
A
01–1
A#
10–2
B
11–3
Rest / Silence
Reserved
Reserved
1 KHz (normal
beep)
Updated April 2, 2009
Octave
1
2
3
4
Advertisement
Table of Contents
