Table of Contents
Advertisement
Models TF6 and TM6
Width
Depth
Height
Weight
Figure 4. SureMark printer dimensions (Models TF6 and TM6)
Power requirements
SureMark printers do not contain a power supply. When the printer is operating in
EIA-232 mode, an external power supply must be attached to connector J2 of the
interface card of the printer. This connector is located under the printer and is
accessible without removing the printer covers. (See Figure 5 on page 18 for
thermal/impact SureMark printers, and Figure 6 on page 19 for single-station
SureMark printers.) Connector J2 has the following pin functions:
When the SureMark is operating in RS-485 mode, power is supplied to the printer
from the IBM POS system. The system supplies 38V dc and 5V dc to the printer.
When the SureMark has the USB feature installed and is using the powered USB
cable with a SurePOS 700 Series system, 24 V is supplied from the system unit.
12
SureMark Printers User's Guide
145 mm (5.7 in.)
177 mm (7.0 in.)
Front: 95 mm (3.7 in.), Rear: 121 mm (4.8 in.)
1.4 kg (3.0 lb) without paper
Table 2. J2 connector pin assignments
Pin
Signal
1
+24 V dc
2
Not Connected
3
Ground
Updated April 2, 2009
Advertisement
Table of Contents
