Intermec EasyCoder 3400e User Manual page 90

EasyCoder 3400e Bar Code Label Printer User's Manual
To adjust the label rest point
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while turning on the printer.
3. In the top bank of the Test and Service DIP switches, turn off switch 1 and turn on
4. In the bottom bank of the Test and Service DIP switches, turn on or off the
5. Press the Feed/Pause button.
6. Verify that the label rest point number on the software configuration label matches
7. Try printing again to see if you need to readjust the DIP switches in the bottom
8. If you need to readjust the DIP switches in the Bottom Bank, repeat Steps 4 through
6-10
The printer prints the hardware configuration test label and then enters Data Line
Print mode.
switches 2 and 3.
To adjust the label rest point forward (feed more label), turn off DIP switch 4.
To adjust the label rest point backward (retract label), turn on DIP switch 4.
Top Bank
OFF
ON
1 2 3 4
Switch settings
for feeding
label forward
appropriate DIP switches. See the Dot Increments DIP Switch Settings table on
page 6-8.
The printer prints the software configuration label and stops at the new location.
the number you set in Step 4.
bank.
7. If not, exit Test and Service mode by turning off the printer and returning all DIP
switches to their original settings.
Top Bank
OFF
ON
1 2 3 4
Switch settings
for retracting label
3XXXU.48