Intermec EasyCoder 3400e User Manual page 11

Analysts and programmers should use this manual to learn how to operate, program,
and connect the EasyCoder® 3400e printer to a network or system. The first part of this
manual tells you how to install, operate, maintain, and troubleshoot your printer. The
last part of the manual covers advanced features of the 3400e printer. A basic
understanding of DOS, programming, and data communications is necessary.
This table summarizes the information in each chapter of this manual:
For Information On
Installing the printer
Operating the printer
Routine maintenance
Troubleshooting
Improving printer
performance
Test and Service features
Specifications
Character sets
Communications
Full ASCII chart
Refer To
Chapter 1, "Getting Started." Tells you how to plug in the printer,
load fanfold media, configure the serial port, and print a
configuration test label.
Chapter 2, "Operating the Printer." Explains the printer front panel,
tells you how to load roll media, load ribbon, test for
communications, and download fonts.
Chapter 3, "Maintaining the Printer." Shows how to maintain the
printer.
Chapter 4, "Troubleshooting." Instructs how to clear error messages
and troubleshoot programming or configuration problems.
Chapter 5, "Optimizing Printer Performance." Tells you how to fine-
tune the printer to increase processing time.
Chapter 6, "Using Test and Service Mode." Provides information on
using Test and Service mode to print test labels, perform Test and
Service mode procedures, and configure DIP switch settings.
Appendix A.
Appendix B.
Appendix C.
Appendix D.
Before You Begin
xi