Intermec EasyCoder 3400e User Manual page 76

EasyCoder 3400e Bar Code Label Printer User's Manual
The label mark sensor detects the mark on the back of continuous media stock. The
printer uses the output to determine the start of print. The label mark sensor is behind
the platen roller and near the inboard edge of the printer.
To adjust the label mark sensor
1. Remove the media cover and locate the label mark sensor.
2. Use your index finger to slide the label mark sensor to the correct position for your
3. Enable mark printing with PrintSet, your third-party software, or IPL commands.
4. Print a few labels or press Feed/Pause two times to make sure that the label mark
5. Replace the media cover.
5-6
media. You can position the label mark sensor anywhere from the inboard edge of
the printer to the center of the paper path.
For help, see PrintSet online help, your third-party documentation, or the IPL
Programming Reference Manual.
sensor is detecting the black mark on the media.
NugFont
HelvC
C 39