Intermec EasyCoder 3400e Install Manual

Cutter tray

Hide thumbs Also See for EasyCoder 3400e:

Download this manual See also: Instruction Manual, User Manual

3400, 4420, and 4440 Cutter Tray Instruction Sheet

You can use two different cutter trays to collect cut labels from your 3400, 4420,

and 4440 printers:

The basic cutter tray (Part No. 067324)

The deluxe cutter tray (Part No. 066369)

Both trays hook easily onto the cutter. On the deluxe cutter tray, you can adjust

the angle of the tray and the depth of the tray to match the amount of labels

you plan to cut.

To attach the basic cutter tray

1. Attach the cutter to your printer. For help, see the 3400, 4420, and 4440

Cutter User's Manual (Part No. 066391).

2. Slide the tray arms under the mounting plate hinges and hook the tray arms

onto the hinges. The tray rests against the front of the printer.

Basic

tray

44XXT.002

067548-001

Cutter

cover

Mounting

plate hinge

Page 1 To attach the basic cutter tray 1. Attach the cutter to your printer. For help, see the 3400, 4420, and 4440 Cutter User’s Manual (Part No. 066391). 2. Slide the tray arms under the mounting plate hinges and hook the tray arms onto the hinges.
Page 2 Note: Depending on the angle of the tray, it may hang down below the bottom of the printer. If you want the tray to rest at a steep angle, move your printer so that the front is at the edge of the surface it is sitting on.
Page 3 Attaching the Deluxe Cutter Tray 6. Making sure that the top of the tray rests against the cutter cover, adjust the tray to the angle you choose. 7. Tighten the thumbscrews to secure the angle of the tray. Base thumbscrew Tray base 067548-001 Cutter...

4420 4440 34006732466369