Intermec EasyCoder 3400e User Manual page 45

NugFont
HelvC
To print a software configuration label
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while turning the printer on. The printer
prints out a hardware configuration label.
3. Set the DIP switches to print out the software test label.
Top Bank Set switches 1 through 6 and 8 off. Set switch 7 on.
Bottom Bank Set switches 1 through 8 off.
4. Hold the Feed/Pause button down for 1 second. The printer prints out the software
configuration label.
5. Return the DIP switches to their original settings.
6. Turn the printer power off and then on.
For direct thermal media, use the three-digit sensitivity number located on the roll of
media to set the sensitivity number. You can also use the values from the tables in the
next section.
For thermal transfer media, you need to look in two places to determine the sensitivity
number. The sensitivity number on each roll of thermal transfer media or ribbon has an
asterisk (*) in place of one of the digits. On thermal transfer media, the rating contains
the first and second digits, with an asterisk in place of the third digit. The number on
the ribbon has the first and third digits, with an asterisk in place of the second digit.
To optimize the sensitivity number for thermal transfer media, you combine the digits
as in this example.
Media or Ribbon
Thermal transfer media
Thermal transfer ribbon
C 39
Sensitivity
Number Description
56* The asterisk reserves the third digit to identify
the ribbon's sensitivity number.
5*7 The asterisk reserves the second digit to identify
the media's sensitivity number.
567 Optimized sensitivity number
Operating the Printer
2
2-13