Intermec EasyCoder 3400e User Manual page 29

NugFont
HelvC
You need to configure the serial port of the printer to match the configuration of your
PC or network controlling device. If the printer's default settings do not match, use the
DIP switch settings table to configure the serial port.
To configure the printer serial port
1. Use the following DIP switch setting descriptions and table to locate the DIP
switches you need to change to configure the serial port.
2. Use a small straight-slot screwdriver to set the appropriate DIP switches.
For example, if you want to change the media type to thermal transfer, set DIP
switch 8 on the bottom bank of switches to the on position.
3. Turn the printer power off and then on for the configuration changes to take effect.
Note: Ignore Multi-Drop switches if you are not using a Multi-Drop network.
DIP Switch Setting Descriptions
Parameter Description
Baud rate
Parity
Data bits
Stop bits
Multi-Drop address
Protocol
Media type
C
The rate, in bits per second, at which the host exchanges data with
the printer. The maximum baud rate is 115,200.
Adds one bit (1 or 0) to the character to make the sum of bits always
odd or even.
The number of bits that represent the ASCII characters.
Timing units between characters that synchronize character
transmission.
Unique address for each device connected with Multi-Drop
protocol.
The transmission standards for communication between the printer
and each connecting device.
Enables the printer to work with either direct thermal or thermal
transfer media.
1
39
Getting Started
1-15