Porter-Cable PCB222TS Instruction Manual page 35

prOBLEm
Material kicked back
from blade .
Blade does not raise or
tilt freely .
Blade does not come
up to speed. Reset trips
too easily.
Machine vibrates
excessively.
Does not make accurate
45° and 90° crosscuts.
for assistance with your product, visit our website at www.portercable.com for a list of service centers, or call the
Porter-Cable Customer Care Center at (888) 609-9779.
pOSSIBLE cAuSES
. Rip fence out of adjustment.
. Riving knife not aligned with blade.
3. feeding stock without rip fence.
4. Riving knife not in place.
5. Dull blade.
6. The operator letting go of material before it
is past saw blade.
7. Blade bevel lock handle is not tight.
. Sawdust and dirt in elevation/tilting
mechanisms.
. Extension cord too light or too long.
. Low house voltage.
. Saw not mounted securely to workbench.
2. Bench on uneven floor.
3. Damaged saw blade.
. Miter gauge out of adjustment.
. Align rip fence with miter gauge slot.
. Align riving knife with blade.
3. Install and use rip fence.
4. Install and use riving knife (with guard).
5. Replace blade.
6. Push material all the way past saw blade
before releasing work.
7. Tighten the handle.
. Brush or blow out loose dust and dirt.
. Replace with adequate size cord.
. Contact your electric company.
. Tighten all mounting hardware.
2. Reposition on flat level surface.
3. Replace blade.
. Adjust miter gauge.
35
cOrrEcTIvE AcTION