Porter-Cable PCB222TS Instruction Manual page 15

SeTTING UP THe STAND (FIG. B, B-1)
. Lift up the stand to its vertical position, as shown in
step  of fig. B.
. Unfold the stand by stepping on the foot pedal ()
to release the locking treadle hook (), and press
down on stand handle until the stand is in its lowest
position. NOTE: You should hear a click when locked
in place.
Fig. B
Fig. B-1


WArNINg
!
for your safety, never connect plug to power source
receptacle until all assembly and adjustment steps are
complete, and you have read and understood the safety
instructions.
ASSEmBLINg TABLE SAW TO STANd (fIg. c)
. Lift the saw body () and place on the stand (),
aligning the four mounting holds (3) on the saw base
with the four threaded mounting holes on the top
plate of stand.
. Bag "M" - Attach the table saw to the stand with four
hex head bolts (4) and washers (5).
3. Tighten all mounting bolts with a 3 mm wrench.
NOTE: Do not overtighten the four bolts as this may
cause damage to the base of the saw.
1 1
1
4
3
Fig. C

NOTE: Before using the saw, verify that the table saw is
securely locked in position.
FOLDING THe STAND (FIG. B-1, D)
. hold the stand handle and press down the red stand
locking lever (3) to release the hook (4). (fig. B-)
. Slowly lift up on the stand handles until you hear a
click from the foot pedal locking in place. Now the
stand is folded as shown in fig. D and is ready for
storage or transportation.
Fig. D
INSTALLINg THE TABLE INSErT (fIg. E)
. To install the table insert () onto the saw table, align
the two tabs () into the two recesses (3) located in
the back of the table opening.
. Press down on the front of the table insert () to
engage the clip (4) located on the front of the insert.
NOTE: You should hear a "click" sound when table
insert is installed correctly and locked into position.
Fig. e

3
5
3

1

4
5
4