Porter-Cable PCB222TS Instruction Manual page 16

AdJuSTINg THE TABLE INSErT (fIg. f)
WArNINg
!
To avoid serious injury, the table insert (2) must be
level with the table. If the table insert is not flush
with the table, adjust the four bolts (1) with a 4 mm
hex wrench until it is parallel with the table.
NOTE: To raise the insert, turn the hex screws
counterclockwise. To lower the insert, turn the hex
screws clockwise. Do not remove the insert, adjustments
need to be made with the insert in place to get the
proper level.
Fig. F

STOrAgE
Rip fence and miter gauge storage (Fig. G)
Storage for the rip fence (), miter gauge () are located
on the left side of the saw housing.
Fig. G

3

3
3


Push stick storage (Fig. H)
A storage holder for the push stick () is located on the
left side of the saw housing.
. Store the push stick () by hanging it on the holders ()
through the holes (3) of the push stick ().
Fig. H

3
Blade guard assembly storage (Fig. I)
Storage for the blade guard assembly () is located on
the left side of the saw housing.
. Take the blade guard assembly () and tilt it upside
down as shown in fig. I. Align the two slots () on
the right side of the blade guard to the holders (3).
. Slide the assembly forward locking into place.
Fig. I
3

6