Operation - Porter-Cable PCB222TS Instruction Manual

BASIc SAW OpErATIONS
rAISE THE BLAdE (fIg. mm)
To raise or lower the blade, turn the blade elevation
handwheel () to the desired blade height, and then
tighten the blade bevel lock handle () to maintain the
desired blade angle.
Fig. MM
4
TILTINg THE BLAdE (fIg. mm)
. To tilt the saw blade for bevel cutting, loosen the
blade bevel lock handle () and turn the blade tilting
handwheel (3).
. Tighten the blade bevel lock handle () to secure.
ON/OFF SWITCH (FIG. NN)
The ON / Off (I/O) switch has a black removable safety
key. With the key removed from the switch, unauthorized
and hazardous use by children and others is minimized
and the saw will not turn on.
. To turn the saw "ON," insert the key () into the
slot of the switch (), and move the switch upward to
the "I" (ON) position.
. To turn the saw "Off," move the switch downward to
the "O" (Off) position.
3. To lock the switch in the Off position, grasp the
sides of the safety switch key, and pull it out.
4. With the switch key removed, the switch will not
operate to power the saw on.
5. If the switch key is removed while the saw is running,
it can be turned "Off" but cannot be restarted
without inserting the switch key.
WArNINg
!
ALWAYS lock the switch "OFF" when the saw is
not in use. Remove the key and keep it in a safe
place. In the event of a power failure, blown fuse,
or tripped circuit breaker, turn the switch "OFF"
and remove the key, preventing an accidental
startup when power comes on.

OpErATION



3
Fig. NN
OvErLOAd prOTEcTION (fIg. mm)
This saw has an overload reset button (4) that resets
the motor after it shuts off due to overloading or low
voltage. If the motor stops during operation, turn the
ON/Off switch to the "O" (Off) position and unplug
the saw. Wait about five minutes for the motor to cool,
plug in the saw, push in the reset button (4) and turn the
switch to the "I" (ON) position.
uSINg THE duST pOrT (fIg. OO)
WArNINg
!
To prevent fire hazard, clean and remove sawdust from
under the saw frequently.
To prevent sawdust buildup inside the saw housing,
attach a vacuum hose () (hose is not included) to
the dust port () at the rear of the table saw. DO NOT
operate the saw with the hose in place unless the
vacuum is turned on.
Fig. OO

uSINg THE TABLE EXTENSION (fIg. pp)
NOTE: Use the scale on the front rail for rip cuts up to
6 in. (406.4 mm). for rip cuts in 6 in. (406.4 mm) to
30 in. (76 mm), follow the below instructions.
. Move the rip fence to the 6 in. (406.4 mm) mark on
the right side of scale (this is marked with a red line
on the scale) and lock down the fence.
. Unlock the table extension by releasing the cam lock
lever ().
3. Slide the table extension with the fence to the
desired location using the scale located on the
rear rail.
4. Lock the fence into position by pressing down the
cam lock lever ().
6