Porter-Cable PCB222TS Instruction Manual page 23

. Raise the riving knife () to its highest position
(through cut position). Take the anti-kickback pawls
assembly and lift up the locking lever () located on
top. (fig. BB)
3. Place the front of assembly into slot (3) and push
down, making sure the assembly is engaged in the
slots. Push down on the locking lever () to lock.
(fig. BB, CC)
NOTE: Make sure the anti-kickback pawls assembly
is locked in position before operating saw.
Fig. BB

Loosen

Fig. CC

Tighten
4. Take the blade guard (4) and press down on the red
spring button (5) located on the top of assembly.
(fig. DD)
5. Position blade guard over the riving knife () and
align the slot (6) to the riving knife () as shown in
fig. DD.
6. Lower the guard assembly (4) onto riving knife ().
Release the red spring button (5) so that two
latches (7) engage into two locking hooks (8)
completely. (fig. DD, EE)
7. Make sure that the assembly is locked in place both
in front and back. (fig. EE)
WArNINg
!
To reduce the risk of serious injury, use saw blade
guard and riving knife for every operation for which
it can be used including all through sawing.
3
removing the blade guard and anti-kickback pawl
assembly (Fig. BB, ee)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
. With the blade elevation handwheel, raise the blade
. Loosen the blade bevel lock handle and turn the
3. Tighten the blade bevel lock handle.
4. Remove the anti-kickback pawls assembly by lifting
5. Remove the blade guard assembly by pressing down
3
Fig. DD
5
4

8
Fig. ee
WArNINg
!
to the maximum height.
handwheel to 90° on the bevel scale.
the anti-kickback pawls lever (). (fig. BB)
the red spring button (5) and lifting up the assembly.
(fig. EE)
Press Down
5
6
7
5