Set Up For Bistro 10 Unit; Product Installation Procedure - Newco Bistro 10 Operating Instructions Manual

Set up instructions for Bistro 10 Machine
Fill and install ingredient hoppers with nozzles turned up, Chocolate on left and Milk on right.
Make sure "button" on bottom of hopper is seated in slot in sheet metal. Slight manual rotation
of the auger gear may be necessary to seat hopper in correct location.
Rotate dispense nozzles down into whipper bowl.
Turn machine on, machine should start filling, will shut off when full.
Heater will turn on when tank is at probe level and will display Heating: Please Wait. When
machine temperature reaches brew temp, display will change to "Ready to Brew". If brew is
initialized before tank temperature is reached, machine will display "Heating" until temp is
reached, then will start dispensing.
Place an empty cup in the dispense area, open the powdered hopper door, and depress the
"Rinse" button next to the whipper bowl until the water runs clear.
To dispense a drink, place a cup under the dispense area, press a brew selection, and
press the button on the keypad which corresponds to the drink desired. When the drink
is finished, the machine will beep 3 times and the display will change to "Place cup,
Centered-Select Your Drink"
NOTE: TO DISPENSE HOT WATER PUSH AND HOLD "HOT WATER"
BUTTON, WATER WILL DISPENSE UNTIL BUTTON IS RELEASED,
OR TIMES OUT AT 12 SECONDS

Product Installation Procedure

• Open product box and remove the BIB product. Place in Coffee
BIB Tray, Fig. 2, and (Newco PN 121929) as shown in Fig. 3.
2.10.14
Fig. 1
Fig. 2
9
Fig. 3