Newco Bistro 10 Operating Instructions Manual page 13

Programming Instructions (Cont'd)
Pressing the "COFFEE-MILD" Button will select the Mode Displayed
Pressing the "LATTE" Button will scroll forward through the Select Menu Choices
Pressing the "CAPPUCCINO" Button will scroll backwards through the Select Menu
Choices
Pressing the "LATTE" button repeatedly will loop the display in 5 Modes:
Maintenance---Statistics---Setup---Calibration –Recipe Entry--Exit Program Mode
Maintenance
1. Press Button to Select "Maintenance"
2. Press "LATTE" Button to toggle Select Menu display
Install Sanitizing solution-Push Newco Coffee Logo to Start Sanitation Cycle (See Pages 22 - 26)
Push & Hold Newco Coffee Logo to Prime Pump (See Pages 22 - 26)
Whipper Seal Remaining (Remaining powdered drink cycles before changing the whipper seal)
Whipper Seal Reset (Select this after changing the whipper seal to reset whipper seal countdown)
Exit Maintenance Mode
Statistics
1. Press Button to Select "Statistics"
2. Press "LATTE" Button to Toggle display forward
Information Display Only
2.10.14
REPLACEMENT WHIPPER SEAL PN 781566
SEE PAGE 21 [replace after 5000 cycles]
Total run cycles on machine
Total Gallons water used
Chocolate Powder Remaining
Milk Powder Remaining
Exit Statistics Mode
13