Newco Bistro 10 Operating Instructions Manual page 25

1. Remove the product BIBs from the machine and connect a BIB
of cleaning solution to the PUMP BIB connector as shown in
figs. 1-4 pages 22-24.
2. Enter "Programming Mode" by pressing and holding "Newco"
logo button for 2 seconds.
3. Display will change to "Install Cleaning solution" "Press Reset
[Newco] to Start Cleaning Cycle".
4. Place an empty 12 oz cup in the dispense area then press the
reset [Newco] button to start the Cleaning Cycle. Cycle will
start and finish automatically.
5. When cleaning cycle ends (2.5 minutes total: pump 45 sec., dwell
90 sec., & water 15 sec.), the buzzer alarm will sound 3 times if
enabled during the "Set-Up Programming".
6. When cleaning cycle ends, disconnect the BIB of cleaning
solution from the Pump BIB connector and replace the coffee
BIB product. The machine will automatically advance to the
Prime Pumps mode.
7. To Prime: Press and hold the "Reset" [Newco] button until a
steady stream of product flows from the dispense area into the
vessel.
8. Press and release the "Latte" Switch until "Exit Maintenance
Mode" appears on the display- Press "Coffee Mild" button to
exit.
9. Press and release the "Latte" Switch until "Exit
Programming Mode" appears on the display- Press "Coffee
Mild" button to exit and return to normal Run mode.
10. Discard the Contents of the 12 oz cup
2.10.14
Daily Cleaning Instructions
25