Newco Bistro 10 Operating Instructions Manual page 28

Whipper System Maintenance-Cont'd
Lubrication
As the whipper motor spins at a very high rate of speed, it is important to minimize friction
between the motor shaft and the rubber seal to extend the life of both components. After
disassembling and cleaning the whipper components with warmer water, add lubricant [item #:
900039] to the whipper motor shaft before re-installing the base. The lubricant should be applied
approximately on the center shaft [where the seal will sit]. Do not apply lubricant to the complete
shaft as this is not required.
Replacing Worn Components
The whipper system is equipped with a drainage system in case liquid
gets past the seal and behind the base. Should this occur liquid will drip
from the handle area as an indication that the seal is worn. At this point,
the whipper system must be taken apart, cleaned, and the worn seal must
be replaced
2.10.14 28