Face And Glass Removal - Lopi Cypress GSR Owner's Manual

Finalizing the Installation

Face and Glass Removal

! Make sure the gas control valve is "OFF" and the heater is cool prior to conducting service.
a
Remove the two screws
securing the stove top.
Lift the stove top off the
stove and place it aside.
Lift the glass frame slightly, swing the top forward, then lift
c
the glass frame to disengage it from the bottom guides.
Glass Frame
Glass Frame Guide
Re-Attaching the Glass Frame:
a) Slide the two brackets on the bottom of the glass frame into the glass
frame guides (hold the glass frame at a slight angle.
b) Swing the glass frame into place - you may have to lift it slightly to
allow it to fit over the top of the firebox.
c) Attach the upper latches (follow the instructions above in reverse).
d) Replace the stove top and secure with the two screws.
© Travis Industries
Phillips
b
Screwdriver
Latch
Catch
(on glass frame)
4121109
(for qualified installers only)
Open the two latches holding the
glass frame in place - follow the
directions shown below
Top of
Firebox
Glass
23
100-01329.docx