Before You Begin; Remote Set-Up; Verify The Insert Is Plugged In; Synchronize The Transmitter To The Receiver - Lopi Cypress GSR Owner's Manual

26

Before You Begin

Warning: Read this entire manual before you use your new stove (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property
damage, bodily injury, or even death.
Warning: Do not operate appliance with the glass front removed, cracked or broken. Replacement of
the glass should be done by a licensed or qualified service person.

Remote Set-Up

Verify the Insert is plugged in

The insert should be plugged in before synchronizing the remote.

Synchronize the Transmitter to the Receiver

The transmitter will need to be synchronized to the receiver before the remote will work correctly.
Synchronizing is done in the following two steps below (see Figure 1):
a) Press the PRG (Program) button on the receiver using a paperclip or equivalent device (receiver
will beep 3 times).
b) Press the "ON" button on the transmitter (receiver will beep 4 times).
NOTE: If power is cut off to the receiver for an extended period of time, you may need to re-synchronize
the remote.
© Travis Industries
Operation
"Beep"
"Beep"
"Beep"
4121109
"Beep"
"Beep"
"Beep"
"Beep"
Figure 1
100-01329.docx