Lopi Cypress GSR Owner's Manual page 44

Optional Equipment
44
9. Use the included torx wrench to remove the stock stepper motor (it may be discarded). The stepper
motor (adjustable regulator) has an installation sheet included with it – make sure to follow all of the
directions. Place the stepper motor on the gas control valve (see below) – MAKE SURE IT IS
CORRECTLY ORIENTED. Secure using the screws included with the motor (see below) – tighten to
25 Lb-inches. Leak test this area after installation to verify proper installation.
10. Restore the appliance to the correct configuration. Make the gas line connection, bleed the gas line
(if applicable), start the heater and thoroughly leak-test all gas connections and the gas control valve.
© Travis Industries
(for qualified installers only)
Figure 14
4121109
Figure 15
100-01329.docx