Lopi Cypress GSR Owner's Manual page 43

Optional Equipment
6. Install the LP (propane) manifold cover included in owner's pack (see illustration below).
7. Install the LP pilot orifice following the directions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then
replace the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
a
Before replacing the burner, check the instructions for the type of media you are using (log,
stone, or driftwood). Depending upon media type, you may be required to modify the stove.
8. Replace the burner, making sure it is correctly seated. Replace the ember trays.
© Travis Industries
Natural Gas Orifice = .020N (3way)
LP (Propane) Orifce = .014LP
7/16" Wrench
4121109
(for qualified installers only)
.020N
or
.018N (2way)
.018N
.014LP
43
b
100-01329.docx