Table of Contents
Advertisement
Handle assembly
To remove the top/side cover, do the following:
1.
Power-off the server, if it is on.
2.
Unplug the server.
3.
Remove the cover (see "Removing the side cover" on page 40).
4.
Remove the front bezel (see "Removing the bezel" on page 41).
5.
Remove the handle assembly (see "Handle assembly").
6.
Remove the four screws from the back of the server and put them in a safe place.
7.
Using a screwdriver, gently pry the cover away from the server in the rear and
slide the unit away from the server.
Before you begin:
•
Read "Safety information" on page 105.
•
Review the information in "Before you begin" on page 38.
FRU information (service only)
81
Advertisement
Table of Contents
