Table of Contents
Advertisement
Troubleshooting the Ethernet controller
Network connection problems
Ethernet controller troubleshooting chart
18
Hardware Maintenance Manual: xSeries 200
If you have just added new software or a new option and the server is not working, do
the following before using the error symptoms table:
•
Remove the software or device that you just added.
•
Run the diagnostic tests to determine if the server is running correctly.
•
Reinstall the new software or new device.
This section provides troubleshooting information for problems that might occur with
the 10/100 Mbps Ethernet controller.
If the Ethernet controller cannot connect to the network, check the following:
•
Make sure that the cable is installed correctly.
The network cable must be securely attached at all connections. If the cable is
attached but the problem persists, try a different cable.
If you set the Ethernet controller to operate at 100 Mbps, you must use Category 5
cabling.
If you directly connect two workstations (without a hub), or if you are not using a
hub with X ports, use a crossover cable.
Note: To determine whether a hub has an X port, check the port label. If the label
contains an X, the hub has an X port.
•
Determine if the hub supports auto-negotiation. If not, try configuring the
integrated Ethernet controller manually to match the speed and duplex mode of
the hub.
•
Check the LAN activity light (if available) on the front of the server. The LAN
activity light illuminates when the Ethernet controller sends or receives data over
the Ethernet network. If the LAN activity light is off, make sure that the hub and
network are operating and that the correct device drivers are loaded.
•
Make sure that you are using the correct device drivers, supplied with your
server.
•
Check for operating server-specific causes for the problem.
•
Make sure that the device drivers on the client and server are using the same
protocol.
•
Test the Ethernet controller.
The way you test the Ethernet controller depends on which operating system you
are using (see the Ethernet controller device driver README file).
You can use the following troubleshooting chart to find solutions to 10/100 Mbps
Ethernet controller problems that have definable symptoms.
Advertisement
Table of Contents
