Table of Contents
Advertisement
Setup
Setup and Installation CD
won't start.
ServeRAID program cannot
view all installed drives - or -
cannot install NOS.
The Operating System
Installation program
continuously loops.
ServerGuide won't start your
NOS CD.
Can't install NOS - option is
grayed out.
TechConnect CD
Can't start TechConnect CD.
Can't view publications from
TechConnect CD, or text is
unreadable.
Diskette Factory CD
Get "time out" or "Unknown
host" errors
POST error codes
Error Code/Symptom
062
(Three consecutive boot
failures using the default
configuration.)
101, 102, 106
(System and microprocessor
error)
111
(Channel check error)
94
Hardware Maintenance Manual: xSeries 200
•
Be sure the server is supported; all eServers with a startable (bootable) CD-ROM
drive are supported.
•
If the startup (boot) sequence settings have been altered, be sure the CD-ROM is
first in the boot sequence.
•
If more than one CD-ROM drive is installed, be sure that only one drive is set as
the primary drive. Start the CD from the primary drive.
•
Be sure there are no duplicate SCSI IDs or IRQ assignments.
•
Be sure that the hard disk drive is connected properly.
Free up more space on the hard disk.
Be sure the NOS CD you have is supported by ServerGuide. See the Setup and
Installation CD label for a list of NOS versions supported.
Either there is no logical drive defined (ServeRAID systems) or the ServerGuide system
partition is not present. Run the setup and configuration program.
Be sure you're starting the CD on a system with Microsoft Windows installed.
Be sure you have the Adobe reader installed (available from the TechConnect CD).
Be sure you have access to the Internet through FTP directly.
In the following error codes, X can be any number or letter.
1.
Run Configuration/Setup
2.
Battery
3.
System Board
4.
Microprocessor
1.
System Board
1.
Failing adapter
2.
DIMM
3.
System board
Action
Action
Action
FRU/Action
Advertisement
Table of Contents
