Button Kit; Guide Assembly / Speaker - IBM x Series 200 Hardware Maintenance Manual

Button kit

Guide assembly / speaker

78
Hardware Maintenance Manual: xSeries 200
6. Gently slide the floppy disk drive toward the front of the server and lift it out.
Before you begin:
• Read "Safety information" on page 105.
• Review the information in "Before you begin" on page 38.
To remove the button kit, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see "Removing the side cover" on page 40).
4. Remove the front bezel (see "Removing the bezel" on page 41).
5. Remove the hot-swap hard disk drive (see "Hard disk drive cage" on page 73).
6. Disconnect the cable of the button kit from the system board.
7. Place a screwdriver against the bottom release latch of the button kit and gently
press upward and slide the latch through the aperture.
8. Gently pinch together the upper release latches and slide the latches through the
aperture and remove the button kit.
Before you begin:
• Read "Safety information" on page 105.
• Review the information in "Before you begin" on page 38.