Table of Contents
Advertisement
"NO RX PAPER" (#012)
Cause:
The receiving fax machine declares no paper in DIS, or its memory is full.
Solution: Contact the other party, and ask them to put paper in their machine, or to clear
their fax machine's memory.
"NO TEL #" (#022)
Cause:
The key you pressed has no number registered for One-Touch Speed Dialing,
Coded Speed Dialing, or Group Dialing.
Solution: Print a list of registered numbers and make any corrections needed, then try again.
"NOT AVAILABLE" (#025)
Cause:
One-touch or coded speed dial already registered.
Solution: Check the contents of the one-touch or coded speed dialling registration, then try
again.
"PROBLEM READING CARD"
TURN OFF AND ON
Cause:
There is a problem with the card slot.
Solution: (1) Switch power OFF/ON.
(2) Replace the multi card reader board.
(3) Replace the SPCNT board.
"PUT IN CARTRIDGE"
Cause:
The printhead is not set.
Solution: Set the printhead.
Cause:
The printhead is set incorrectly.
Solution: Set the printhead correctly.
"TRY AGAIN IN B/W" (#085)
Cause:
You tried faxing a color document to a machine that does not support color
faxing.
Solution: (1) Change the setting of MENU> MAINTENANCE> TX SETTINGS>
COLOR DIRECT TX to ON.
(2) Try sending again in black & white.
(3) Check the received fax machine's setting for color faxing is available.
"WAIT COOLING"
Cause:
The printhead is hot.
Solution: Wait until the message disappears.
MultiPASS MP730/MP700 Chapter 4: Maintenance and Service
4-15
Advertisement
Table of Contents
