6.2.5 PRINT test
Pressing the 3 key from the test mode menu selects the print test. This test prints various
patterns. For servicing, use the 3-8: CHECKERS pattern (press the 8 key from the print test
menu). The other patterns are not to be used since they are for development and factory
personnel. End this test by pressing the Stop/Reset key.
Check the pattern for the following:
If the print test is normal, make a copy of a document. If the copy is faulty, the
reading section is faulty.
NOTE
Please do not select the following menus:
3-1: CLR PTN1 3-2: CLR PTN2
If a mistake is made and these menus are selected, the value of #7 PRINTER
#5. INK ABS CAPA will be reset to 0%.
Replace the waste ink absorber and set to 0% in TEST mode.
MultiPASS MP730/MP700 Chapter 4: Maintenance and Service
Figure 4-24 Print Test Pattern Check
4-51
Check for any vertical or horizontal white
stripes on the black squares.
Also, check that all the squares have
straight edges on all four sides.