Attention To Bepaid During Assembly/Disassembly; Safety Cautions - Canon MP 700 Service Manual

1. ATTENTION TO BEPAID DURING ASSEMBLY/DISASSEMBLY

1.1 Safety Cautions

Electrical shock
In order to prevent any risk of electrical shock, always be sure to check that the power cord
and modular jack have been removed. Also, remove all cables connecting to the computer.
When conducting service that requires the main unit to be powered on, be sure to wear some
kind of earthing, such as a wrist strap, etc. Otherwise, there is a danger of conduction and
electrical shock.
Parts which are generally likely to cause electrical shock are as follows.
• Power supply unit primary (supplied with AC voltage)
• Telephone line primary
• LBP engine high voltage contacts (for high voltage during developing and transfer)
High temperature
In order to prevent burns during disassembly, allow at least ten minutes, after the power has
been switched off, for the high temperature components to cool down.
General high temperature components are as follows.
• Motors
• Power supply unit
• Elements on driver ICs, etc., on PCBs (in particular, ICs with heatsinks)
• BJ cartridge aluminium plate (for BJ cartridge engine models)
• Fixing unit and peripheral covers (for LBP engines)
Battery Replacement
The batteries must be replaced correctly to avoid explosion. Do not replace any battery with
one not indicated for the machine, ie., use one of the same type or equivalent. Be sure to
dispose of used batteries according to local laws and regulations.
Fire
It is dangerous to throw lithium batteries and parts and components containing flammable
substances, such as cartridges, etc., into fire. Such parts and components must be disposed of
in accordance with local laws and regulations.
Ignition
When using solvents such as alcohol, etc., while conducting service, there is a danger of fire
igniting from heat from internal circuitry and from sparks. Before using any such solvents, be
sure to switch off the power and allow time for high temperature parts to cool down. Make
sure that there is sufficient ventilation when working with solvents.
Movable parts
In order to prevent accidents with movable parts, be sure to remove the power cable when
conducting service that requires disassembly. Also, take care that personal accessories and
hair, etc., are not caught in any moving parts.
MultiPASS MP730/MP700 Chapter 3: Assembly and Disassembly
3-1