Quadra-Fire Isle Royale 823-0170-MBK Owner's Manual page 28

3 . Dis pos al of As hes
• W hen ash is within 1 - 3 /4 in. ( 4 4 mm) of firebox
lip
• H omeowner
Ashes should be placed in a metal container with a
tight fitting lid. The closed container of ashes should
be placed on a non-combustible floor or on the ground,
well away from all combustible materials, pending final
disposal.
If the ashes are disposed of by burial in soil or otherwise
locally dispersed, they should be retained in the closed
container until all cinders have thoroughly cooled.
WARNING
F ire Ris k .
Dis pos al of As hes
• Ashes should be placed in metal container with tight
fitting lid.
• Do not place metal container on combustible surface.
• Ashes should be retained in closed container until all
cinders have thoroughly cooled.
4 . Cleaning P lated Surfaces
• P rior to first burn and then as desired
• H omeowner
Clean all the fingerprints and oils from plated surfaces
B EF ORE firing the appliance for the first time. If not
cleaned properly before lighting your first fire, the oils
can cause permanent mark i ngs on the plating.
After the plating is cured, the oils will not affect the
finish and little maintenance is required. Wipe clean
as needed.
• Do not use polishes with abrasives.
It will scratch plated surfaces.
P age 2 8
R
Is le Royale Wood Stov e
CAUTION
5 . G las s Cleaning
• As desired
• H omeowner
Clean glass with a non-abrasive glass cleaner. Abrasive
cleaners may scratch and cause glass to crack .
deposits on the glass are not very heavy, normal glass
cleaners work well. H eavier deposits may be removed
by using a damp cloth dipped in wood ashes or by using
a commercially available oven cleaner.
After using an oven cleaner, it is advisable to remove any
residue with a glass cleaner or soap and water. O ven
cleaner left on during the next firing can permanently
stain the glass and damage the finish on plated metal
surfaces.
A portion of the combustion air entering the firebox is deflected
down over the inside of the door glass. This air flow "washes"
the glass, helping to k eep smok e from adhering to its surface.
When operated at a low burn rate, less air will be flowing over
the glass and the smok e y, relatively cool condition of a low
fire will cause the glass to become coated.
Operating the appliance with the Primary Air Control all
the way open for 1 5 - 2 0 minutes should remove the built up
coating.
CAUTION
H andle glass assembly with care.
When cleaning glas s :
Glass
Assembly
• Avoid striking, scratching or
• Do NO T clean glass when hot.
• Do NO T use abrasive cleaners.
• Use a hard water deposit glass cleaner on white film.
• Use commerical oven cleaner on heavier deposits.
• Remove all residue of oven cleaner or will permanently
stain glass on next firing.
•
Refer to maintenance instructions.
2 5 0 - 5 7 6 3 F
slamming glass.
M arch 2 1 , 2 0 1 3
If the