Quadra-Fire Isle Royale Instructions Manual
Quadra-Fire Isle Royale Instructions Manual

Quadra-Fire Isle Royale Instructions Manual

Non-catalytic, top-load, wood heater
Hide thumbs Also See for Isle Royale:

Advertisement

This manual contains instructions for Installation, Operation & Maintenance.
Please read this entire manual before you install and use your new room heater. Failure to follow
instructions may result in property damage, bodily injury, or even death.
1) When installing your stove, particular attention should be paid to fire protection. If this room heater is not
properly installed, a house fire may result. To reduce the risk of fire, follow the installation instructions. Contact
local building or fire officials or authority having jurisdiction about restrictions, installation inspection and
permit requirements in your area.
2) CAUTION: Never use gasoline or gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to
start or "freshen up" a fire in this heater. Keep all such liquids well away from heater while it is in use.
3) During operation, if any part of the stove starts to glow, the stove is in an overfired condition. Close the air controls
completely until the glowing has stopped. OVERFIRING VOIDS YOUR WARRANTY!
4) Cool ashes should be disposed of carefully, using a metal container.
5) Do not burn wet or green wood. Store wood in a dry location.
6) DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPHTHA OR ENGINE
OIL. Do not burn treated wood, or wood with salt (driftwood, etc.). Burning materials other than wood
(including charcoal) under adverse conditions may generate carbon monoxide in the home, resulting in
illness or possible death.
7) Do not permit creosote or soot to accumulate excessively in the chimney or inside the firebox.
8) Check your chimney system thoroughly when installing into an existing metal or masonry chimney. Seek
professional advice if in doubt about its condition.
9) Do not connect this unit to a chimney flue already serving another appliance.
10) Comply with all minimum clearances to combustibles as shown in this manual for this appliance.
11) Build fire on brick firebox floor. Do not use grates, andirons or other methods to support fuel.
12) HOT WHILE IN OPERATION! Keep children, pets, clothing and furniture away. Contact can cause skin burns.
13) Do not connect to any air distribution duct or system
14) RISK OF FIRE! Do not operate with stove door open, without the firescreen, or ash removal system door open.
15) For further information refer to NFPA 211 (USA) or CAN/CSA-B365 (Canada).
16) Do not operate without fully assembling all components. Burning your stove without the legs attached (if supplied
with unit) will void your warranty, and could present a serious safety hazard
17) Do not oeprate with broken glass..
PRIOR TO FIRST FIRE: Remove all labels from glass. Clean plated surfaces with a glass cleanser and soft
1445 North Highway
Colville, WA 99114-2008
Isle Royale
Non-Catalytic, Top-load, Wood Heater
IMPORTANT SAFETY NOTES:
cloth to prevent staining from fingerprint oils.
SAVE THESE INSTRUCTIONS
250-5763B
February 4, 2005
R
Beaverton
Tested and
O-T L
Oregon USA
Listed by
C
OMNI-Test Laboratories, Inc.
www.quadrafire.com

Advertisement

Table of Contents
loading

Summary of Contents for Quadra-Fire Isle Royale

  • Page 1 Isle Royale Non-Catalytic, Top-load, Wood Heater Beaverton Tested and O-T L Oregon USA Listed by OMNI-Test Laboratories, Inc. This manual contains instructions for Installation, Operation & Maintenance. Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death.
  • Page 2: Serial Number Label Location

    Hearth & Home Technologies welcomes you to our tradi- hand-finished for lasting beauty and enjoyment. Our pledge tion of excellence! In choosing a Quadra-Fire appliance, to quality is completed as each model undergoes a quality you have our assurance of commitment to quality, durabil- control inspection.
  • Page 3: Table Of Contents

    Isle Royale Wood Stove TABLE OF CONTENTS PRE-USE CHECK LIST Listings & Safety Notices ........3 Serial Number Label Location .........2 Place the unit in a location near the final instal- Pre-Use Checklist .............3 lation area and follow the procedures below.
  • Page 4 FIRE SAFETY: To provide reasonable fire safety, the following should be given serious consideration: tion of the QUADRA-FIRE ISLE ROYALE woodstove. This stove meets the U.S. Environmental Protection Agency’s 1990 particulate Install at least one smoke detector on each floor of your emission standards.
  • Page 5: Dimensions

    Isle Royale Wood Stove DIMENSIONS LABEL IS LOCATED ON THE BACK OF THE STOVE SIDE VIEW FRONT VIEW 22-3/4" (578mm) 29" (737mm) 16-3/4" (425mm) 30" (762mm) 30" (762mm) 26-7/16" (570mm) 8-1/4" (210mm) 16-1/2" 28-3/4" (730mm) (419mm) 24-5/8" (625mm) SIDE VIEW...
  • Page 6: Top & Rear Vent Installations

    Isle Royale Wood Stove CLEARANCES TO COMBUSTIBLES (UL and ULC) 8" max ceiling Ceiling mantel 26-7/16" (672mm) 21-5/8" (549mm) if Hearth Legs installed Shown with Hearth Legs MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS In Inches & (Millimeters) NOTE: "A" ,"C" and "F" Dimensions are to the inside diameter of the flue collar.
  • Page 7: Floor Protection

    Isle Royale Wood Stove FLOOR PROTECTION The floor must be non-combustible material, extending beneath heater and to the front, sides and rear as indicated. The floor must be non-combustible or otherwise adequately protected from radiant heat given off by the unit and from sparks and falling embers.
  • Page 8: Alternate Floor Protection Calculation

    Isle Royale Wood Stove Calculating Alternate Floor Protection 3. Turn vent to horizontal position. Inspect sealant to ensure a leak free application. Material 4. Re-assemble in reverse order. Thermal Conductivity: k value The k value indicates the amount of heat (in BTU’s) that will flow...
  • Page 9: Chimney Height Requirements & Draft

    Isle Royale Wood Stove Three factors work together as a system to create the flue CHIMNEY HEIGHT REQUIREMENTS / DRAFT draft; 1) availability of combustion air; 2) heat generated from the fire, and 3) diameter and height of the flue system..
  • Page 10: Flue & Venting Systems

    Isle Royale Wood Stove FLUE SYSTEMS The flue should be checked to determine that it is not oo large for the stove. NFPA 211 allows the cross-sectional area of the flue to be no more than 3 times the cross-sectional area here are two separate and different parts to a flue system: the...
  • Page 11: Solid Pack Chimney With Metal Supports As A Thimble

    Isle Royale Wood Stove SOLID PACK CHIMNEY WITH METAL SUPPORTS AS A THIMBLE For the method of installation to a masonry chimney shown in Figures 12A & 12B, (page 12) it will be necessary to purchase a 12 inch (305mm) long 8 inch (203mm) inside diametert, section of prefabricated listed solid pack chimney to use as a thimble.
  • Page 12 Isle Royale Wood Stove SOLID PACK CHIMNEY WITH METAL SUPPORTS AS A THIMBLE (CONT'D) First, make the frame for the thimble, ensuring it Min. Chimney Clearance is no smaller than 14 inches (356mm) square to Min. Clearance to Wall Spacer and maintain a 2 inch (51mm) air space around the 2"...
  • Page 13: Masonry Fireplace

    Isle Royale Wood Stove CONNECTION TO A MASONRY FIREPLACE There are several kits available to connect the stove to a NOTE: For instances with a fireplace measuring less than masonry fireplace. Look for a listed kit. The kit is an adapter 30 inches in height, Hearth Legs (see Accessories on page which is installed at the location of the fireplace damper.
  • Page 14: Metal Prefabricated Chimney

    Isle Royale Wood Stove CONNECTION TO A METAL PREFABRICATED CHIMNEY When a metal prefabricated chimney is used, the manufac- turer’s installation instructions must be followed precisely. It will be necessary to install the ceiling support package Combustible Outside Wall Maintain 2" (51mm) Listed or wall pass through, “T”...
  • Page 15: Mobile Home Installation

    Isle Royale Wood Stove MOBILE HOME INSTALLATION You must use a Quadra-Fire Outside Air Kit Part 831-1780 for installation in a mobile home. An outside air inlet must be provided for combustion and must remain clear of leaves, debris, ice and/or snow. It must be unrestricted while...
  • Page 16: Outside Air Kit Installation

    Isle Royale Wood Stove OUTSIDE AIR KIT INSTALLATION Included in Kit: 1 flex flange; 2 cable ties; oustide air termination cap; mounting screws (Discard the remaining parts). Items Needed for Installation: 4 inch (102mm) diameter flex pipe in the length as required for your installation;...
  • Page 17: Burning Process

    In order the burn. The coals burn with hot blue flames. to improve the situation, we at Quadra-Fire have developed cleaner-burning wood stoves that surpass the requirements It is very important to reload your stove while enough lively for emissions established by our governing agencies.
  • Page 18: Heat Output Setting

    HEAT OUTPUT SETTINGS For maximum operating efficiency with the lowest emissions, follow these operating procedures: Regardless of desired heat output, when loading stove, burn your Quadra-Fire with both air controls wide open for 5 to 15 minutes. Regulate burn rate (heat output) by using the Primary Air Slide Control (center under ashcatcher).
  • Page 19: Building A Fire

    Isle Royale Wood Stove OPERATING INSTRUCTIONS (Cont’d) CAUTION: Before lighting your first fire in the stove: 1) make certain that the baffle is correctly posi- tioned. It should be resting against the rear support; 2) Follow instructions on page 22 for cleaning plated surfaces, and;...
  • Page 20: Burn Rates

    Isle Royale Wood Stove OPERATING INSTRUCTIONS (Cont’d) BURN RATES • STARTING FIRE: Start fire with both controls fully open (Start-up Air Control pushed all the way IN and Primary Slider Control all the way to the LEFT.) Close Start-up Air Control after approximately 5 to 15 minutes, •...
  • Page 21: Maintenance

    The amount of ash is dependent on the type of wood being burned. The firebox of your Quadra-Fire stove is lined with high quality firebrick, which has exceptional insulating properties. There DO NOT ALLOW ASHES TO BUILD UP IN THE ASHPAN is no need to use a grate;...
  • Page 22: Glass Care & Replacement

    Isle Royale Wood Stove MAINTENANCE (CONT'D) GLASS CARE GLASS REPLACEMENT Replace with 5mm ceramic glass only OTE: Remove all labels from glass prior to lighting the first fire. Ensure that the fire is out and the appliance is cool to This stove is equipped with ceramic, heat-resistant glass, the touch.
  • Page 23: Brick Replacement

    Isle Royale Wood Stove MAINTENANCE FIREBRICK REPLACEMENT Ensure that the firebricks are correctly positioned as referenced by diagram below, and that the firebox does not contain any broken brick prior to operating the unit. 1-1/16" 8-1/4" 4-1/2" 3-3/4" 9" Ø...
  • Page 24: Exploded View

    Isle Royale Wood Stove Baffle Assembly Grate Rear Baffle Filler Griddle Rear Channel Bottom Assembly Griddle Handle Rear Shield Brick Assembly Hopper Lid Stop Side Tertiary Channel, Right Door Assembly Manifold Tube, #4 Side, Left Face Assembly Primary Air Channel...
  • Page 25: Accessories & Service Part

    Appliances Part No. Isle Royale, Matte Black, MBK 823-0170 Isle Royale, Porcelain Mahogany, PMH 823-0300 Isle Royale, Porcelain Creme, PCR 823-0190 Isle Royale, Porcelain Midnight Blue, PMB 823-0200 Isle Royale, Porcelain Green, PGR 823-0200 Page 25 February 4, 2005 250-5763B...
  • Page 26: Service & Maintenance Log

    Isle Royale Wood Stove Service and Maintenance Log Date of Service Performed By Description of Service Page 26 February 4, 2005 250-5763B...
  • Page 27: Warranty

    Isle Royale Wood Stove Lifetime Warranty LIMITED LIFETIME WARRANTY The Hearth & Home Technologies limited Lifetime Warranty guarantees that the following components will work as designed for the lifetime of the stove or Hearth & Home Technologies will repair or replace them. These items include but are not limited...
  • Page 28: Contact Information

    Hearth & Home Technologies 1445 North Highway Colville, WA 99114 Division of HNI INDUSTRIES www.quadrafire.com Please contact your Quadra-Fire dealer with any questions or concerns. For the number of your nearest Quadra-Fire dealer, call 1-800-926-4356 CAUTION • Do NOT discard this manual.

Table of Contents