MUTOH ValueJet VJ-1204 User Manual page 11

Important
Do not install the printer places where there is a possibility that the printer may be damaged or might fall
by chance.
On a shaky stand
•
Slanting location
•
Places where vibration of other machines etc. is transmitted
•
Do not stand on the printer or do not place heavy things on top of it. The printer may be damaged or
might fall by chance.
When not in use, cover the printer with a blanket and do not close the vent. If the vent is closed, the
printer could accumulate heat inside and may cause fire.
Do not install the printer in places where the humidity is high and in a dusty environment. It could lead to
electric shock and fire.
Do not use a damaged power cable. It could lead to an electric shock and fire.
Do not take out or insert the power plug with wet hands. This could lead to an electric shock.
Do not connect earth cables in the following areas :
• Gas pipes. Doing so may cause fire or an explosion.
•
Earth terminals for telephone lines or lightning rods. Doing so may cause a large flow of voltage if
lightning occurs.
•
Water pipes or faucets. If there is a plastic part in the pipe, the grounding will not work correctly.
Do not store combustible materials on the print platform. It could lead to fire when raising the
temperature.
Do not insert or drop metal or objects which are easily combustible through the openings such as fresh
air inlet into the printer. It could lead to an electric shock and fire.
When foreign substances or liquids such as water entered the printer, do not use the printer. It could
lead to an electric shock and fire. Immediately switch off the power, disconnect the power plug from the
electric socket, and contact your local MUTOH dealer.
While installing optional items, be sure to switch OFF the power of the printer and pull out the power
plug. It could lead to an electric shock.
Wire the various codes (cable) as explained in the User's Guide. Wrong wiring could cause fire.
Be sure to use the power cable supplied with the printer. If other power cables are used, it could cause
an electric shock or fire.
Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V - 240 V). If a power
supply other than the specified voltage is used, it could cause an electric shock and fire.
Take power for the printer directly from the power socket (AC 100 V - 120 V or AC 220 V - 240 V). Do
not use complex multiple plugs on the same socket. This could generate heat and might cause fire.
Be sure to use a dedicated power socket with earth wire for the power supply, and connect it to the
earth wire. If the earth wire is not connected, an electric shock or fire may occur.
The waste fluid from the printer should be considered as industrial waste. Proper waste fluid disposal
according to industrial waste disposal laws of your local governments are required. Consign disposal of
waste fluids to specialized processor.
11 AP-75740 – Rev 1.2 – 6/07/2011
User's Guide ValueJet 1204
Chapter 2: Product Overview