MUTOH ValueJet VJ-1204 User Manual page 84

4.8.1.11 Dryer menu
Set up the After Heater temperature. Set this menu to dry the print.
Notes
•
Temperature to be set for the after Heater varies depending on the media which is used for
recommended temperature settings of the after Heater; refer to the "Recommended media list".
Setup Item
After Heater Off / <30° C> to 50° C
—
4.8.1.12 StandbyHeating menu
Set up whether each heater is preheated (idle heat) while in standby mode.
Setup Item
StandbyHeating Off
<On>
—
4.8.1.13 Vacuum Fan menu
Set up the vacuum fan operation.
Setup Item
Vacuum Fan Low
<High>
—
Setting Value
Setting Value
Idle heat is not performed.
Idle heat is performed.
•
•
Setting Value
Set when using soft media.
Set when regular media is used.
•
•
Set up the after Heater temperature.
1. Roll media
2. Dryer- After heater
3. Print head
•
[Enter] key: Save the setting and shift to the
previous hierarchy.
•
[Cancel] key: Cancel the setting and shift to
the previous hierarchy.
Description
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
Description
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
84
User's Guide ValueJet 1204
Chapter 4: Handling the printer
Description
AP-75740 – Rev 1.2 – 6/07/2011