MUTOH ValueJet VJ-1204 User Manual page 56

Notes
•
Make sure the roll media is properly wound up on the media core.
•
If the front edge of the roll media is not straight, cut it straight on beforehand.
•
If the front edge of the roll media is curled, cut it off on beforehand.
•
For the cutting method, refer to topic "Cutting media".
Open the front cover, and pull out the roll media about 0,5 m.
Step 4 :
Wind back the roll media with the scroller while pressing down the media at the front side of the
Step 5 :
printer. This will reduce bending and avoid slant of the media.
Pull the media hold lever forward.
Step 6 :
N°
1 Front cover
2 Roll media
N°
1 Roll media
2 Scroller
N°
1 Media hold lever
56
Chapter 4: Handling the printer
Name
Name
Name
AP-75740 – Rev 1.2 – 6/07/2011
User's Guide ValueJet 1204