Table of Contents
Advertisement
LS 6000i Series Product Reference Guide
Time to Return to Continuous
Omnidirectional
This parameter sets the time the scanner issues a single
scan line on trigger pull before returning to the constant-
on omnidirectional pattern. It is programmable in 0.1
second increments from 0.0 to 9.9 seconds. If this value
is set to 0, the trigger mode will not return to constant-on
omnidirectional automatically. In this case, pull the
trigger twice quickly to return to the constant-on
omnidirectional pattern.
To set this time, scan the bar code. Next scan two
numeric bar codes beginning on page 5-138, the first
representing seconds, the second tenths of seconds. If
you make an error, or wish to change your selection,
scan
CANCEL bar code on page
5-143.
TIME TO RETURN TO CONTINUOUS OMNI
5-56
Advertisement
Table of Contents
