Programming
Laser On Time
This parameter sets the maximum time decode
processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9
seconds.
To set a Laser On Time, scan the bar code below. Next
scan two numeric bar codes beginning on page
5-138
that correspond to the desired time on. Single digit
numbers must have a leading zero. For example, to set
a Time On of 0.5 seconds, scan the bar code below, then
scan the "0" and "5" bar codes. If you make an error, or
wish to change your selection, scan
CANCEL bar code
on page
5-143.
LASER ON TIME
5-63