LS 4071 Product Reference Guide
Laser On Time
This parameter sets the maximum time decode processing continues during a
scan attempt. It is programmable in 0.1 second increments from 0.5 to 9.9
seconds.
To set a Laser On Time, scan the bar code below. Next scan two numeric bar
codes beginning on page 5-98 that correspond to the desired time on. Time less
than 1.0 second 1414must have a leading zero. For example, to set a Time On of
.5 seconds, scan the bar code below, then scan the "0" and "5" bar codes. If
you make an error, or wish to change your selection, scan CANCEL on page
5-100
LASER ON TIME
5-14