Table of Contents
Advertisement
Section 5 Maintenance and Lubrication
Clutch Run-In
Refer to Figure 5-4:
Clutch Run-In
Figure 5-4
The clutch should slip during operation to protect the cut-
ter from excessive loads.
Prior to initial operation and after long periods of inactivity,
the Friction Clutch should be "run-in".
1. Tighten all 4 nuts uniformly until the spring load is low
enough that the clutch slips freely with the PTO en-
gaged.
2. Turn nuts fully back. Clutch is ready for use.
Lubrication
Lubrication
Legend
14265
14268
20
RC35120 RCM35120 Rotary Cutter 312-301M
Table of Contents
10103
Multipurpose
spray lube
Storage
At the end of the working season or when the cutter will not
be used for a long period, it is good practice to clean off
any dirt or grease that may have accumulated on the cut-
ter and any of the moving parts.
1. Clean the Rotary Cutter as necessary.
2. Check the blades for wear and replace if necessary.
3. Inspect the cutter for loose, damaged or worn parts
and adjust or replace as needed.
4. Lubricate as noted in "Lubrication", below.
5. Store the Rotary Cutter inside if possible for longer
Rotary Cutter life.
6. Repaint parts where paint is worn or scratched to pre-
vent rust. Ask your dealer for Aerosol Land Pride
Beige touch-up paint #821-011C.
Multipurpose
Multipurpose
grease lube
oil lube
Pivoting Upper Hitch
Type of Lubrication: Multipurpose Grease
Quantity = 6 pumps
Lift-Type Tailwheel Spindle Hub
Type of Lubrication: Multipurpose Grease
Quantity = 6 pumps
Land Pride
Intervals at which
50
lubrication is required
24
24
7/14/08
Advertisement
Table of Contents
