Parking Brake; Deck Clutch Switch; Deck Lift Pedal - Land Pride Accuz Z52 , Z60, Z72 Operator's Manual

Section 2 Operation
Left/Right Fuel Tank Valve
Refer to Figure 2-3:
The mower is equipped with a Left/Right Fuel Tank Valve
that will determine which fuel tank the mower is operating
from. It is not important which fuel tank the mower is using.
Left/Right Fuel Tank Switch
Figure 2-3
Blade Engagement Switch
Refer to Figure 2-2:
This switch engages the deck blades. Pull the switch up to
engage and push switch down to disengage the clutch.
IMPORTANT: Never engage clutch with engine
running at high rpm or when the deck is under load.
Clutch, belts or deck could be damaged.
Control Levers

Parking Brake

The Parking Brakes are applied by moving the control
levers from the Neutral Position (Figure 2-5) to an outward
position (Refer to Figure 2-4). Each rear wheel brake
operates independently of the other.
!
WARNING!
In the event of a system failure while mowing, engage both
parking brakes to stop or slow mower. Refer to Figure 2-4.
Control Levers in Parking Brake Position
Figure 2-4
14 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M
Refer to Figure 2-5:
These levers control the mower's speed, direction, neutral
lock and park brake. Levers are used to steer, accelerate,
brake and change direction. The mower will not move
when the engine is on, drive pumps are operating and the
control levers are in the park brake position (out)
Figure 2-4.
Control Levers
!
WARNING!
The parking brake is not designed to hold the mower on steep
slopes.

Deck Lift Pedal

Refer to Figure 2-6:
The deck lift pedal is used to raise or lower the deck. Push
on the pedal to raise the deck and then place the deck
height locking pin into the desired cutting height hole.
Push the deck lift pedal to raise the deck when going over
obstructions.
Deck Height
Locking Pin
19698
Control Levers
Figure 2-5
Deck Lift
Pedal
Deck Lift Pedal
Figure 2-6
Land Pride
19060
19061
03/11/03