Section 1 Assembly and Setup
NOTE: Chain should be attached to PTO at imple-
ment end of shaft.
Top Link Alignment
Figure 1-7
6. Slide PTO shaft over the tractor's splined PTO shaft
and secure with locking device of PTO shaft.
7. Secure chain on PTO to hitch brace on cutter to re-
strict outer shield of PTO from rotating.
8. PTO shaft should now be moved back and forth to in-
sure that it is secured to the shafts of the tractor and
cutter gearbox.
14260
12
RC35120 RCM35120 Rotary Cutter 312-301M
Table of Contents
Refer to Figure 1-8:
9. Should the PTO shaft require shortening:
a. Hold the half shafts next to each other in the short-
est working position and mark them.
b. Shorten inner and outer guard tubes equally.
c. Shorten inner and outer sliding profiles by the
same length as the guard tubes.
d. Proper overlap is a minimum of one-half the
length of each tube, with both tubes being of equal
length.
e. Round off all sharp edges and remove burrs.
Grease sliding profiles.
11420
Refer to Figure 1-9:
10. If check chain kit is purchased, assemble to cutter.
Check Chain Assembly
Figure 1-9
Shortening PTO Shafts
Figure 1-8
Land Pride
13588
7/14/08