Pull-Type Cutter; Tongue; Refer To Figure - Land Pride RC35120 Operator's Manual

Land Pride
Section 1 Assembly and Setup

Pull-Type Cutter

Tongue

Refer to Figure 1-3:

1. Position tongue (#1) in front of cutter as shown. Block
tongue in or near a horizontal position.
2. Assemble tongue to lower hitch plates welded to cut-
ter deck with the 1 5/8" x 1 1/8" x 2" long spacers (#2),
7/14/08
Table of Contents
14257
1 1/8" x 4" long bolts (#3), and lock nuts (#17).
3. Attach safety chain (#4) to tongue (#1) using two 1"
USS flat washers (#5) and 1" nylon lock nut (#6).
4. Install the hydraulic hose loop (#7) on the deck behind
the right hand lower hitch plate using a 3/8" x 3/4" long
bolt (#8), lock washer (#9), and flat washers (#10).
5. Install jack (#11) to tongue and secure with pin (#12).
Tongue Assembly
Figure 1-3
RC35120 RCM35120 Rotary Cutter 312-301M 9