Driveline Protection; Clutch Run-In; Disassembly And Assembly - Land Pride AFM4214 Operator's Manual

Land Pride
Section 5: Maintenance & Lubrication

Driveline Protection

!
CAUTION
Engage parking brake, disengage PTO, shut off tractor, and
remove key before working on or around the driveline and/or
slip clutch.
!
CAUTION
A slip clutches that has been in use or has been slipped for
only two or three seconds during run-in may be too hot to
touch. Allow a hot clutch to cool before working on it.
Drive components are protected from shock loads with a
friction slip clutch on the main driveline. The clutch must
be capable of slippage during operation to protect the
gearbox, driveline and other drive train parts.
The friction clutch should be "run-in" prior to initial
operation and after long periods of inactivity to remove
any oxidation that may have accumulated on the friction
surfaces. Repeat "run-in" instructions at the beginning of
each season and when moisture and/or condensation
seizes the inner friction plates.
Hex Head
Socket Bolts

Clutch Run-In

Figure 5-9
Clutch Run-In
Refer to Figure 5-9:
1. Loosen counterclockwise all 8 hex head socket bolts
uniformly 6 full turns.
2. Cycle clutch on and off 5 or 6 times (15 seconds on
and 15 seconds off) with the engine operating at half
throttle. Disengage driveline, shut off tractor and
remove key. Wait for all components to stop before
dismounting from tractor.
3. Tighten hex head socket bolts fully back. Clutch is
ready for use
4. The clutch should be checked during the first hour of
cutting and periodically each week.

Disassembly and Assembly

Refer to Figure 5-10:
If the clutch run-in procedure indicated that one or more of
the friction disks did not slip, then the clutch must be
disassembled to separate the friction disks.
1. Rotate 8 hex head socket bolts (#2) all the way out to
free stop flange (#3).
12/06/11
Table of Contents
(IMPORTANT NOTICE)
Check position of lip on stop
flange (UP or DOWN).
Replace stop flange with lip in
its original position.
21270
22376
2. Rotate stop flange (#3) and remove from
housing (#11)
3. Remove the following inner components:
a. Spring kit (#4)
b. Pressure flange (#5)
c. 1st Friction Disc (#6)
d. Hub with flange and pull collar (#7 & #1)
e. 2nd Friction disc (#6)
f. Intermediate flange (#8)
g. 3rd Friction disc (#6)
h. Hub disc (#9)
i. 4th Friction disc (#6)
j. Bearing (#10)
4. Inspect all components and replace to their original
position. Make certain stop flange (#3) is replaced
with its flanges down as shown.
5. Fully tighten all 8 hex head socket bolts (#2).
AFM4214 and AFM4216 All-Flex Grooming Mowers 315-587M
Clutch Assembly
Figure 5-10
27