Table of Contents
Advertisement
Section 1 Assembly and Setup
Rear Axle
Refer to Figure 1-4:
1. Attach axle assembly (#1) to rear of cutter:
a. Position axle as shown.
b. Attach axle on the right hand side of cutter with
cylinder pivot lug (#2) and 1 1/2" x 1 7/8" long
spacer (#3) on outboard side of pivot, and 1 1/2" x
1" x 1 1/8" long spacer (#4) on inboard side of piv-
ot. Secure with a 1" x 9" long bolt (#5), flat washer
(#6), and lock nut (#7).
c. Attach axle on left hand side of cutter with
1 1/2" x 1" x 1 1/8" spacer (#4) on both sides of piv-
ot. Secure with a 1" x 8 1/2" long bolt (#8), flat
washer (#16), and lock nut (#7).
d. Install outboard axle mounts (#26) to deck mount-
ed supports (#27) with pivot shaft pin (#23) and
secure with 1/4" -20 x 1 1/2" long hex bolt (#25)
and lock nut (#24).
NOTE: 1" bolts should be installed pointing outboard.
2. Install 3 1/2" x 8" hydraulic cylinder (#9) and secure
with 1" pins and clips furnished with cylinder.
3. Route hoses (#10) through hydraulic hose loop (#7)
Refer back to Figure 1-3.
Tailwheel
Refer to Figure 1-4:
1. Attach axle arm weldment (#11) to axle arm mount
with 1" pin (#12) and secure with 5/16" x 2" long bolt
(#16) and lock nut (#14).
10
RC35120 RCM35120 Rotary Cutter 312-301M
Table of Contents
NOTE: Axle arms can be installed with wheels to the
inboard or outboard side.
2. Install rubber bumpers (#15) one on top side of axle
arm mount and one below and secure with 1/2" x 8"
long bolt (#16), rubber stop washer (#17), flat washer
(#19), and lock nut (#18). Tighten lock nut until rubber
bumper compresses to 1 3/4". Refer to
Figure 1-2.
3. Attach wheels with tires mounted (#20) or 15" rims
(not shown) to hubs (#21) with 1/2" -20 x 1 1/8" long
flange bolts (#22).
Leveling Rod
Refer back to Figure 1-3:
NOTE: The leveling rod is to be installed on the left
hand side of the cutter.
1. Insert leveling rod (#13) through trunnion (#14).
2. Screw leveling tube (#5) over leveling rod (#13) and
secure with 1" jam nut (#16).
3. Refer to Figure 1-4, attach clevis end (#28) of leveling
rod to lug (#29) tailwheel axle with 1" x 2" clevis pin
(#30) and secure with hair pin clips (#31).
NOTE: The leveling rod should be adjusted to level
the cutter after attaching cutter to tractor.
Pull-Type Tailwheel & Rear Axle Assembly
Figure 1-4
Land Pride
14258
7/14/08
Advertisement
Table of Contents
